Haier HW90-BP14636 User Manual page 24

9-Troubleshooting
Problem
Excessive foam floats
drum and/or deter-
gent drawer.
Automatic adjust-
ment of washing
time.
Spinning fails.
Unsatisfactory wash-
ing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the appli-
ance, disconnect the power supply and contact the customer service.
9-1
24
Cause
• Detergent is not a appropriate.
• Excessive use of detergent.
• Washing programme duration will
be adjusted.
• Unbalance of laundry.
• Degree of pollution does not agree
with selected programme.
• Detergent quantitiy was not suf-
ficient.
• Maximum load has been exceeded. • Reduce loading.
• Laundry was unevenly distributed
in the drum.
• Insoluble particles of detergent can
remain as white spots on the laun-
dry.
• Caused by fats such as oils, creams
or ointments.
9.4 In case of power failure
A
The current programme and its setting will be saved.
When power supply is restored operation will be re-
sumed.
In case of power failure during programme run door
opening is mechanically blocked. If the laundry is to
be removed, the water level must not be visible in the
glass door. - Danger of scalding!
▶ Lower the water level according to step 1 to 6 of
chapter CARE AN CLEANING (PUMP FILTER).
▶ Pull lever (A) beneath service flap (Fig. 9-1) until
door is unlocked by a gentle click.
▶ Fix all parts and close the service flap.
Solution
• Check detergent recommen-
dations.
• Reduce amount of detergent.
• This is normal and doesn't af-
fect functionality.
• Check machine load and laun-
dry and run a spinning pro-
gramme again.
• Select an other programme.
• Choose the detergent acc. to
the degree of pollution and acc.
to manufaturer specifications.
• Loose the laundry.
• Perform extra rinse.
• Try to brush the points from the
dry laundry.
• Choose an other detergent.
• Pretreat the laundry with a spe-
cial cleaner.
GB