Table of Contents
Advertisement
Installation
7. Using field supplied silicone, apply sealant around economizer hood as shown in
Figure 11.
Horizontal Configuration
To position economizer for horizontal operation, complete the following steps:
1. Remove filter access panel.
2. Remove item 3, adapter panel shown in
3. Remove the bottom three screws and top two screws from the economizer panel.
4. Remove return air blockoff.
5. Pull the economizer assembly and end panel out of the unit.
6. Refer to
Note: (ReliaTel units only) If optional sensors for humidity and temperature monitoring are to be
7. Remove supply and return duct covers from the horizontal openings and install over the
8. To reinstall the economizer, lift into position by fitting the upper left hand corner around the
9. Lift the economizer and panel assembly to align the upper two screw holes. Secure the top by
10. Pull out on the bottom of the economizer and secure bottom left 3.
11. Replace adapter panel removed in Step 2.
12. Secure bottom right with screw engaging into adapter panel.
13. Install the bottom blockoff and secure with 3 screws. Refer to
14. Using field supplied silicone, apply sealant around economizer hood as shown in
10
below.
Figure 3, p. 6
and
used (BAYENTH005A and BAYENTH006B), install them now. Use the instructions provided
in the kits.)
downflow opening.
channel in the cabinet post. Then pivot the economizer into the opening in the cabinet.
inserting 2 screws, top left 1 then top right 2.
Figure 1, p.
Figure 4, p. 6
for reassembly instructions to Horizontal configuration.
5.
Figure 10, p.
9.
Figure 11
Figure
11.
ACC-SVN44D-EN
Hide quick links:
Advertisement
Table of Contents
