Checking The Engine Oil Level; Charging The Battery - Toro Z Master G3 Setup Instruction

11
Installing a Battery (Model
numbers that end with CP
only)
Parts needed for this procedure:
1 Clamp
2 Wing nut (1/4 inch)
2 Battery hold down
Procedure
1. Purchase a 12V battery.
Models with a 29hp engine and below require a
battery with a minimum of 260 CCA.
Models with a 30hp engine and higher require a
battery with a minimum of 340 CCA.
2. Locate the battery mounting hardware and install it
into the machine. Refer to Installing the Battery in
the Operator's Manual.
12

Charging the Battery

No Parts Required
Procedure
Charging the battery produces gasses that can
explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the battery
in an enclosed space.
Important: Do not run the machine with the
battery disconnected; electrical damage may occur
to the engine.
Charge the battery. Refer to the Operator's Manual for
instructions.
13

Checking the Engine Oil Level

No Parts Required
Procedure
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Servicing
the Engine Oil Level in Operator's Manual.
14
Adding Fuel to the Machine
No Parts Required
Procedure
Add gasoline to the machine before starting it. Refer
to your Operator's Manual. for the correct fuel and
procedure.
8
Figure 18