Toro Z Master G3 Setup Instruction page 4

3. Secure the seat plate to the seat with 4 spacers and
4 flange nuts (3/8 inch).
4. Plug the harness connector into the seat switch
located under the seat towards the front.
5. Install the seat to the machine frame with 4 flange
nuts (3/8 inch).
Figure 6
Figure 7
1. Harness connector
6
Installing the Seat (Models that
have a tilting or flip up seat)
Parts needed for this procedure:
1 Seat
4 Flange nuts (3/8 inch)
2 Long spacers (deluxe seats only)
4 Short spacers (deluxe seats only)
Procedure
1. Tilt the seat frame up.
2. For deluxe seats only, install the spacers as shown
in Figure 9.
4
Figure 8
2. Flange nuts