Advertisement
Replace the transmitter battery if transmission becomes weak.
Loosening the two small screws will give access to the battery.
IMPORTANT:
Always use fresh batteries before changing your code. Otherwise the
WARNING:
Changing the code:
1. Hold SW1 (left button).
2. Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.
3. Release SW1.
4. Your unique 32-bit code has been generated and stored.
Return to default code:
1. Hold SW1 (left button).
2. Hold the 'program'-button (SW3). After +/- 10s the led will flash 5 times.
3. Release both buttons.
4. Your code has been reset to the default code.
Receiver instructions
Each transmitter generates a code that must be "known" by a receiver in order to operate.
Proceed to the next step to store one or more transmitters in the receiver memory.
Learn your receiver to recognize a transmitter:
1. Connect the power supply to the receiver unit (see page 2)
2. Hold 'setup' button, 'MODE'-led (8) turns on after a few seconds.
3. Press CH1 remote control transmitter button.
4. 'CONFIRM'-led (10) lights when the code has been grabbed.
5. Release 'setup' button.
If necessary, repeat steps 2 to 5 to learn the codes for other transmitters.
Up to 31 transmitters can be stored. If the memory is full, 'MODE' and 'CONFIRM' will flash
simultaneously when 'setup' button is pressed (see also next page to erase the memory).
transmitter can be damaged .
THIS UNIT CAN NOT BE USED TO OPERATE MACHINES
Advertisement
