Vestil WP Series Instruction Manual page 12

Table of Contents
Step 3: Raise the front guard rail.
Attach
lanyard
to
anchor
point
Pivot the rail assembly
towards the front of the
platform.
Step 5: Secure the platform to the tines of the fork lift both tine
locks and the (yellow) Nylon safety strap.
a.) Tine locks: Review
YOUR FORK TRUCK,
remove the tine lock pins. Drive the forklift tines into the fork
pockets. Reinstall the tine lock pins. Refer to Step 1 and FIG. 5A
& 5B on p. 9).
Nylon safety
b.)
PLATFORM ON YOUR FORK TRUCK, STEP 2
10. As delivered, a safety strap is connected to the base of the
mast guard. Attach the strap to the fork carriage without slack.
LABELING DIAGRAM: WP-3737-FD
Each unit should be labeled as shown in the diagram. Label content and location are subject to change so your
product might not be labeled exactly as shown. Compare the diagram below to your
If there are any differences between actual labeling and this diagram, contact
Replace all labels that are damaged, missing, or not easily readable (e.g. faded). To order replacement labels or to
inquire whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
Sign 082 (on back of mast
guard facing forklift)
Label 218 (on toeboard, both
sides of platform)
Label 287 (on toeboard)
Table of Contents
Secure the assembly in
place with the pegs and
slots.
MOUNTING THE PLATFORM ON
STEP 1 and Fig. 5B on p. 9. Then,
strap:
Review MOUNTING
and Fig. 6 on p.
or by calling (260) 665-7586 and asking for the Parts Department.
Copyright 2020 Vestil Manufacturing Co.
Rev. 4/3/2020
Step 4: Close and latch the gates.
Lift the gate to allow the slots to slide onto the
pegs welded to the toeguard.
THE
Record of Satisfactory
Technical Service.
Sign 080 (facing platform)
Label 253 (facing platform)
Label 821
Label 729
Page 12 of 17
WP, MANUAL
Condition.