Protection Of The Environment - Rowenta Logic TN1010 Instructions For Use Manual

NOT TOND Logic 030109 11/07/03 8:08 Page 12
• For the nape, hold the hair trimmer upturned, pressing lightly against the hair.
GB
• Proceed as shown in the sketch below, moving downwards, in short strokes.
c) Sideburns (fig. 28)
• Move the trimmer downwards, holding it upturned, with the cut line at right angles to the head.
Proceed in short strokes.
13. FOR A SUCCEWSSFUL "SHORT BACK AND SIDES"
With this cut, on the sides and nape only, your hair is kept long on the top (fig. 29).
• Combs necessary: n° 1 or 4, according to the required length (fig. 30).
1st STAGE : THE CUT
• Cut the hair on the nape of the neck and the sides (following the procedure described
in the "Round Crew cut" paragraph), using the hair trimmer fitted with comb n° 1 or 3
(according to the required length), up to point A (see sketch).
• Starting from point A (located a few cm above the ear) (fig. 30), use a flat comb to obtain a perfectly
clean line. Tilt the comb in relation to the skull (fig. 32) and cut the hair exceeding the comb, using the
hair trimmer without its removable combs (use this comb as a guide)
(fig. 31).
• Do not cut the hair on the top.
2nd STAGE : CONTOURS AND FINISH
• See the "Contours and finish" chapter in the "Round Crew cut" section (fig. 33).

14. PROTECTION OF THE ENVIRONMENT

At the end of the life of your product, it should go to a specially-adapted waste recycling centre.