Barthelme CHROMOFLEX RC Manual page 3

CHROMOFLEX RC - Radio Remote Control - Manual - English V1.01 - www.barthelme.de
Top level:
COL+ / COL- select 20 predefined colours:
16 „rainbow colours" and
4 „white colours (with different nuances)".
PRG+ / PRG- select 12 different effects:
1.) Fixed Colour (last saved fixed colour)
2.) Normal Colour Change (all 8 colours of the standard colour table, 5 seconds per colour)
3.) Medium Colour Change (all 8 colours of the standard colour table, 20 seconds per colour)
4.) Slow Colour Change (all 8 colours of the standard colour table, 40 seconds per colour)
5.) „Blob": Randomly uplighted/dimmed colours (from the 8 colours of the standard colour table)
6.) „LSD": Randomly changing colours (from the 8 colours of the standard colour table)
7.) „Fire": Simulation of a burning fire (red and orange)
8.) „Flashes": Bright random flashes over a deep blue (looks very good with several Chromoflex RC)
9.) „Bursts": Randomly selected, non-synchronised flashes (from the 8 colours of the standard colour table)
10.) User Program 1 (can only be modified with the PC software, pre-set: 8 colours with fast changing)
11.) User Program 2 (can only be modified with the PC software, pre-set: red-green-blue)
12.) User Program 3 (can only be modified with the PC software, pre-set: 3 uplighted/dimmed combined colours)
The 2nd level can be activated by pressing the button in the middle (SHIFT, at the same time with the other or first):
DIM+ / DIM- select the 8 level dimming. The dimming level is valid for all effects.
OFF switches off all modules in the network.
With SAVE+OFF all modules are switched off too, but all settings (dimmer, effect, fixed colour) are saved
in the modules's memory and will be recalled after power on.
If the modules hve been switched off, pressing SHIFT will restore the last state.
Pressing the button in the middle longer (SHIFT, >4 seconds), the 3.rd level (= Setup) is activated. In this level the
communication type („Master" / „Normal" and network) can be selected, according to the following table. In the Setup mode
the LED of the Remote Control is blinking.
PRG+
LED
OFF
COL-
SHIFT
DIMMER-
ON
PRG-
SAVE+OFF
- 3 -
COL+
DIMMER+
Subject to technical modifications
Rev 15.03.2008