Husqvarna 122C Workshop Manual page 7

Starter
Assembly
Clean the component parts and assemble in
the reverse order as set out for dismantling.
Wind the new starter cord 3 turns anticlock-
wise around the starter pulley.
Insert the starter pulley in position.
Assemble the starter handle.
Fit the pressure equalisation spring, the drive
disc, the screw and the washer.
502 71 27-02
Assembly
Clean component parts before assembling.
Replace the return spring/starter pulley and
starter cord, if necessary.
NOTE!
The return spring and starter pulley
are supplied pre-assembled and
are fi tted in the starter housing as a
single unit.
Exercise care when opening the
packaging so that the spring does
not fl y out.
Wind the new starter cord 3 turns anti-
clockwise around the starter pulley. Push
it in to the starter pulley's track as illustrated
and then out through the cord guide in the
starter cover.
Make sure that the knot at the end of the
cord is as small as possible.
Lubricate the bearing pin with some grease
and place the starter in position in the starter
cover.
Assemble the starter handle.
Tie a double knot and fold under the free end.
Pull the knot fully into the handle.
The pressure equalisation spring must be
placed in position so that the short spring
end is inserted into the starter pulley.
Place the drive disc over the pressure
equalisation spring.
Fit the screw and the washer.
1
5