I-T-E Connecting Studs (RS5785, RS5786)
General
These connecting studs can be used on 3-pole circuit
breakers and on line and load terminals. Both the long stud
RS5785 and the short stud RS5786, can be used on adjacent
poles or alternated, as required by the installation.
Connecting Studs Attached To Breaker
Mounting Preparation
A.
Turn off and lock out all power supplying circuit breaker
before installing.
B.
Drill mounting panel as shown in drilling plan, Figure 1.
This user provided panel must be made from a material
acceptable for supporting uninsulated live parts and
have adequate strength to support the circuit breaker.
Thickness should be 1/4 in. min. and 1 in. max.
C. Figures 1 and 2 show dimensioning information which
can be used to plan the circuit breaker termination
interface.
Figure 1
Figure 2
1 9