Initial Set Up - LDLC Touch C1 User Manual

1. Insert a micro SD memory card (an 8GB micro SD card of class10 is provided, and the SD
card maximal storage capacity could be up to 64GB) into the camera. Use your fingernail
to insert the micro SD card into the slot. The micro SD card will click into place once it is
inserted past flush.
*When using a micro SD memory card, there should be no data from other devices. If using the MicroSD card for the first
time, please format it to FAT32.
The micro SD cards of class 10 or higher speed are recommended. To by the class 10 micro
SD cards please go to our official website : www.ldlc.com.
2. Place battery into the camera
3. Charge the battery
2 batteries of 1050 mAh are included with the LDLC Touch C1 camera. When fully char-
ged, batteries provided up to 2 hours of battery life. The lithium-ion battery comes partially
charged. To charge, connect the included USB cable to camera and connect the other end
of the cable to a power source such as AC charger. No damage will occur to the camera or
battery if used prior to a full charge.
Powering ON / OFF :
Turn on the camera by pressing the Power button
Turn ON
seconds until the red LED flashes. The LCD screen will be ON.
Turn the camera off by pressing the Power button
for at least 3 seconds. To save power, the camera will automatically
To stop
turn off if no button is pressed for more than 3 minutes in standby
mode.

initial set up

for at least 3
in standby mode
37