Table of Contents
Advertisement
035-09651-001-A-0304
WARNING: Do not permit overhanging structures or shrubs to
obstruct air discharge.
Additional height may be required for snow clearance if winter
operation is expected.
FIG. 2 - VERTICAL AND HORIZONTAL APPLICATIONS
VERTICAL / HORIZONTAL INSTALLATION
These indoor units are shipped for vertical installation with ver-
tical air discharge as shown in Figure 2(A) but may be con-
verted for horizontal installation as shown in Figure 2(B) by
interchanging the solid bottom panel and the return air duct
flange.
DUCT CONNECTIONS
Design and install all ducts in accordance with all national
and/or local codes.
Ducts should be sized no smaller than the duct flanges on the
unit or the electric heater (if used). Refer to the unit dimensions
(Fig. 12) and the heater detail (Fig. 3) for these sizes. Refer to
Form 035-16602-002 for installation instructions on the electric
heater.
Use flexible fiber glass or plastic cloth collars or other nonflam-
mable material at the unit duct connections to minimize the
transmission of noise and vibration.
Insulate all ductwork running through unconditioned areas to
prevent moisture condensation and to provide more economi-
cal operation.
Unitary Products Group
The return air duct flange is factory-mounted on the front of the
unit, but it can be reversed with the solid bottom panel for hori-
zontal applications.
A supply air plenum (Fig. 4), a base (Fig. 5) and a return air
grille (Fig. 6) are available as field-installed accessories, and
one of the following respective instructions will be packed with
each.
FIG. 3 - ELECTRIC HEATER ACCESSORY
(Vertical Arrangement Shown)
FIG. 4 - SUPPLY AIR PLENUM ACCESSORY
(Vertical Arrangement Shown)
FIG. 5 - BASE ACCESSORY
(For Vertical Arrangement Shown)
5
Hide quick links:
Advertisement
Table of Contents
