Troubleshooting - ALDI FERREX XG-KF2000 User Manual

Troubleshooting

Trouble
Engine will not start
32
e-mail: info.aldi@positecgroup.com
MODEL: . XG-KF2000 • 03/2020 • 700069
Possible cause
1. Low on fuel or oil content
2. Engine On/Off switch (2) in "Off"
position
3. Faulty spark plug (20)
4. Choke lever (16) in wrong position
5. Fuel shut-off valve in closed position
6. Unit loaded during start-up
7. Spark plug (20) wire loose
8. Old fuel in carburettor
9. If all of the above checked ok
Digital Inverter Generator with Pure Sine Wave
Suggested remedy
1a Fully fill tank. Ensure fuel is fresh
1b Ensure oil is at the the correct level.
Refer page 18-19 of this manual.
1c Ensure the generator is horizontal and
not on an angle.
1d Turn the fuel tap lever to the right
in a clockwise direction to turn OFF
the fuel tap / lever(23). Loosen the
carburettor drain screw. Allow the fuel
in the carburettor bowl to totally drain.
When the fuel has stopped draining,
turn the fuel tap / lever to the left in an
anti-clockwise direction to turn ON and
fuel starts running out of the carburettor
drain. If so, tighten the screw on the
drain and allow the carburettor to fill
with petrol.
1e If the fuel from the tank does not pass
through the carburettor drain above,
you need to drain the fuel tank (27),
remove the fuel tap / lever (23) and
inspect the fuel extension filter (22).
2. Press the engine On/Off switch (2) to
the "ON" position as indicated by an "I".
3. Replace or clean spark plug (20) Refer
page 27.
4. Adjust choke lever (16) accordingly
Refer to page 22.
5. Open fuel shut-off valve
6. Remove load from unit
7. Attach wire to spark plug (20)
8. Fuel will deteriorate in the carburettor
fuel bowl very quickly. Open the drain
screw in the bowl of the carburettor until
fresh fuel runs through.
9. Take unit to service centre
AFTER SALES SUPPORT
1300 889 028
(toll free)