Advertisement
Available languages
Available languages
Table of Contents
FORM FIT
Acura RDX 2007 -
HARDWARE KIT
4 – Large Bumpons
1 – 32" x 3/8" Roll Gasket
1 – Alcohol Wiping Pad
4 – Expansion Plugs
4 – #6 x ½" Screws
INSTALLATION
1.
Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.
2.
Install the four (4) bumpons as shown.
NOTE: The bumpons must be installed on the hood not on the protector. If the bumpons are installed on the protector, they will
wear through the hood paint.
3.
Open the hood of the vehicle
4.
Wipe the bottom of the hood edge trim where the protective gasket will attach, with the alcohol pad provided.
5.
Measure and mark 70mm in from where the hood edge trims starts. Peel the protective backing from the roll of gasket
material, and attach it to the edge trim at this point as shown below.
70mm
HOOD PROTECTOR
440mm
200mm
45mm
70mm
*
Protective Gasket Placement
TOOLS REQUIRED
1 – Grease Pencil
1 – Tape Measure
1 – Screwdriver #2
100mm
Protector
Hood Edge Trim
HD 1H 07
Hood
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FORM FIT HD 1H 07
Summary of Contents for FORM FIT HD 1H 07
- Page 1 FORM FIT HOOD PROTECTOR HD 1H 07 Acura RDX 2007 - HARDWARE KIT TOOLS REQUIRED 4 – Large Bumpons 1 – Grease Pencil 1 – Tape Measure 1 – Screwdriver #2 1 – 32” x 3/8” Roll Gasket 1 – Alcohol Wiping Pad 4 –...
- Page 2 Periodically check to make sure the bumpons are in place and the protector is secure. Avoid using automatic car washes. Do not pull on the protector when opening or closing the hood. Thank you for purchasing a Form Fit hood protector. Retain this sheet for care instructions and hardware kit information.
- Page 3 FORM FIT Protecteur de capot HD 1H 07 Acura RDX 2007 - LISTE DE PIÈCES OUTILS ET MATÉRIAUX REQUIS 4 – Grosses butées 1 – Crayon gras 1 – Ruban à mesurer 1 – Moyen tournevis à embout étoilé (Phillips n° 2) 1 –...
- Page 4 Éviter de laver le véhicule dans un lave-auto automatique. Ne pas tirer sur le protecteur pour ouvrir et fermer le capot. Merci de vous êtes procuré un protecteur FORM FIT. Conserver cette feuille pour connaître les instructions d’entretien et les renseignements concernant le nécessaire d’installation.
Need help?
Do you have a question about the HD 1H 07 and is the answer not in the manual?
Questions and answers