OPGAL Therm-App MD Pro User Manual page 41

Therm-App MD™ Pro User Manual
PRODUCT USAGE NOTICES
Calibration
The Product makes use of specific calibration data, which was prepared for it in the factory. It is possible that during prolonged field usage of the
Product a deterioration of image will be noticed. In such cases, we recommend that you send in the device for re-calibration at the factory. Please
contact our support team for further instructions.
Accuracy
The system requires 8-10 minutes to achieve steady state needed for the stated accuracy. For optimal performance we recommend waiting up to
40 minutes and have at least 30 people pass in the field of view to create a statistical baseline.
Disposal of electronic waste
As with most electronic products, this equipment must be disposed of in an environmentally friendly way, and in accordance with existing
regulations for electronic waste.
Documentation updates
Our manuals are updated from time to time, and we also issue product-critical notifications occasionally.
16. PRODUCT SAFETY INFORMATION
WARNING
Applicability: Class B Digital Product
This Product has been tested and found to comply with the limits for a Class B digital Product, pursuant to Part 15 of the FCC Rules of the USA.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This Product generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If the Product does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the Product and receiver .
Connect the Product into an outlet on a circuit different from that to which the receiver is connected.
Consult the authorized reseller or an experienced radio/TV technician for help.
WARNING
Do not drop the Product or apply pressure on the IR lens as it may break. If the IR lens breaks, do not touch the broken pieces; the pieces can cause
injury.
WARNING
Be careful when you touch the Product. Some parts of the Product can be sharp and could cause injury.
WARNING
Do not point the infrared detector (with or without the lens and lens cover) at intensive energy sources, for example product s that emit laser
radiation, or the sun. This can have unwanted effects on the performance of the Product. It can also cause damage to the detector.
WARNING
Do not use the Product in a temperature environment higher than +50 degrees Celsius (+122 degrees Fahrenheit), unless specified otherwise in
user documentation or technical data. High temperatures can cause damage to the detector.
WARNING
The Product is not sealed. Avoid exposure of the Product to water, rain or dust.
WARNING
Do not apply solvents or similar liquids to the detector or lens, as this can cause damage.
WARNING
Be careful when you clean the infrared lens. The lens has a delicate anti-reflective coating. Do not clean the lens too vigorously; this can damage
the anti-reflective coating.
Confidential Opgal Propriety
Page 18-41 of 43
Document P/N UM-TAH00AQ-MD-PRO| Rev B