Hisense DH5020K1G Use & Care Manual page 9

Timer
To set Timer for a 30-minute to 24-hour delay
before the dehumidifier is turned off (the
dehumidifier must be On):
1. Press TIMER. Timer indicator light will come
on, and the display will flash. The display will
show remaining time before the dehumidifier
will turn off.
2. Press the Plus or Minus button to change the
delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with
previous setting:
1. Turn off the dehumidifier.
2. Press TIMER. Timer indicator light will flash.
The display will show remaining time before
the dehumiditier will turn on.
3. Press the Plus or Minus button to change the
delay time, from 30 minutes to 24 hours.
To clear the Timer delay program:
NOTE:
Dehumiditier can be either on or off.
1. Press TIMER once after it has been
programmed. Display will show remaining time.
2. While the display is showing the remaining
time, press TIMER again. Timer indicator light
will turn off.
To see the remaining time.
Press TIMER once after it has been programmed.
Display will show remaining time.
NOTE:
Empty the drain water bucket before setting the
timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light
goes on and dehumidification stops.
Clean Filter
1. When the Clean Filter indicator light is on,
remove, clean and replace the air filter. See
"Cleaning the Air Filter".
2. Press the Clean Filter button to reset the filter
monitor.
NOTE:
When the light is on, it will remain on for 180
hours or until you press Clean Filter button.
8