Table of Contents
Advertisement
Electrical Connections
Power Cord
The attached power cord is a standard NEMA 6-15P
cord and is UL approved and listed in the USA and
Canada. It meets the following requirements:
208-240 volt rated;
▯
15 amps.
▯
NOTICES
This appliance is restricted to being powered by the
▯
supplied power cord noted above.
There are two allowable methods to connect the
▯
appliance cord to power:
If the home has an existing 4-prong, 30A Dryer
1.
receptacle use the supplied Power Adapter.
Plug the adapter into the 4-prong receptacle (Line
side) and then plug the Bosch Dryer and Washer
power cords into the adapter (Load side). See
following images of Power Adapter for Line/Load side
locations and appliance cord placement.
NOTICE:
This adapter can only be used with a 4-prong
receptacle. If the home has an existing 3-prong dryer
receptacle it and its complete branch circuit must be
changed to a 4-prong circuit.
Use an existing individual 240V, 15A minimum branch
2.
circuit having a NEMA 6-15R outlet (or choose to have
one installed).
WARNING
9
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK.
Do not reuse this Power Adapter with a new
purchase of a Dryer. The old Power Adapter must
be discarded with the old Dryer. A new Power
Adapter must be used when a new Dryer is
installed.
18
ALL ELECTRICAL CONNECTIONS AND CIRCUITS
WARNING
9
ELECTRIC SHOCK HAZARD
Do not pull on the power cord to unplug the
▯
dryer.
Protect the power cord from physical damage
▯
such as being twisted, kinked, pinched, or walked
on.
DO NOT use an extension cord to connect the
▯
dryer to the power supply.
Make sure:
▯
The power cord fits into the outlet/receptacle.
▯
The home's internal power supply circuit wire size is
▯
sufficient and electrically grounded.
Do not cut, remove or bypass the grounding
▯
prong on the power cord end.
Do not modify the plug provided with the
▯
appliance; if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
The power cord must only be replaced by a
▯
qualified service provider or licensed electrician
to help avoid a fire/electric shock hazard.
Use only manufacturer recommended
replacement power cords purchased through our
Customer Service department.
Do not use NEMA 14-30P (4-prong) nor 10-30P
▯
(3-prong) power cords on this appliance.
Do not reuse old power cord.
▯
Do not make a sharp bend or crimp wiring or
▯
conductors at connections.
WARNING
9
ELECTRIC SHOCK HAZARD
To reduce the risk of electrical shock:
Only pull out the power cord by the plug end and
▯
never by the cord, as this could damage it.
Never touch or hold the plug end or power cord
▯
with wet hands.
Never unplug the plug end during operation.
▯
WARNING
9
ELECTRIC SHOCK HAZARD
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
Check with a qualified electrician or servicer if you
are in doubt as to whether the appliance has been
properly grounded.
Hide quick links:
Advertisement
Table of Contents
