Bosch WTW87NH1UC Use And Care Manual / Installation Instructions page 17

Remove accessories from drum and locate the Tank
1.
Kit containing the blue filter and rubber plug.
Installing the tank plug and filter in place.
CAUTION
9
Condensation water is not suitable for drinking
and may contain lint. Do not drink the
condensation water.
Remove the tank and empty it.
2.
Take the blue filter from the Tank Kit and install it in the
3.
working position as shown in the picture below. Make
sure it snaps completely in place.
Locate the small black plug from the Tank Kit.
4.
Turn the Tank over and you will see a small hole for
5.
the plug to be inserted into. Insert the plug into the
hole. Ensure it is completely inserted and will not fall
out.
Check that both the blue filter and black plug are fully
6.
in their correct positions and insert the complete tank
into its position in the dryer.
Ensure the tank is pushed back into the dryer until you
feel it lock in place
Now you are ready to use the tank for collecting all the
7.
condensate water from the drying process.
NOTICE: If you change the drain system to only use
the tank you are responsible for emptying the tank.
The tank must be emptied at the end of every drying
cycle. It may require additionally emptying during the
drying cycle depending on the size and initial moisture
content of the load. The total capacity of the tank is
approximately 1-1/4 gallons (4.75 liters).
When using the tank only for collecting and draining
the water, the blue filter is required for the Self-
Cleaning system. It is important to clean this filter
periodically.
To clean the blue filter simply lift it up to remove it from
8.
its working position, rinse out and wipe clean and
reinstall it as instructed above. Make sure it snaps
completely in place.
CAUTION
9
If the blue filter is not inserted completely into its
working position lint can travel to the condenser,
during the Self-Cleaning process, and clog/damage
it.
Tip: If you want to use the drain hose to drain the water
in the future, simply reverse the installation steps above
and do all steps from the previous chapter
~ Installation - step by step and check list; Page 15
17