Tools; Installation; Where To Find Additional Instructions Or Technical Documentation; Cleaning After Assembly/Before Commissioning - Lindab Premum Series Installation Instructions Manual

Active chilled beam
Table of Contents

Advertisement

l in d a b | w e si mp l i fy c on st r u ct i on
Installation instruction

2.6 Tools

To install the beam, panel or facade unit, the following tools are required.
Knife
Drill machine
Crowbar
Spirit level
Vacum cleaner

2.7 Installation

It is important to use the correct hangers and the recom-
mended amount for all installation principles. Different
possible installation principles are shown in the installa-
tion instruction and hangers from Lindab should be used
to ensure, that they are intended for the purpose and are
safe to use.
Lindab´s water products can be ordered, to be adapted
to a wide range of different ceiling systems, please check
installation instruction to ensure best adaptation.
The Lindab water products should always be installed
separately hanged up from the recessed ceiling. The
weight of the product should not be covered by the ceiling
system.
Use plastic folio or other to protect the product during on
site construction continually to keep the products in best
condition and avoid any scratches.
4
Gloves
Percussion drill
Tectite tool 12mm
(Order no: 884087)
Lindab PC410
(Order no: 103344)
Dust-cleaner
Lindab reserves the right to make changes without prior notice
2020-04-21
Premum/Premax
Shoes with soft soles
Pencil
Tectite tool small 12mm
(Order no: 646881)
Deburring tool
2.8 Where to find additional instructions
or technical documentation
In the following chapters we will refer to additional tech-
nical documents or/and instructions by a certain keyword
written as a link.
If so you will easily find it with our Lindab Quick Selection
Tool:
www.lindqst.com
1. Visit
www.lindqst.com
2. Select "documentation finder"
3. Select keyword (product name)
4. Follow the link
5. Find your document under "Related documents"
2.9 Cleaning after assembly/ before
commissioning
Please remember to remove plastic folio and other protec-
tion material before commissioning and clean the product
before hand over.
Tape measure
Spanner
Screwdriver
Bits and drills

Advertisement

Table of Contents
loading

Table of Contents