Connections; Electrical Connections; Dmx Connections; Dmx Connection With Terminator Dmx Connection With Terminator - Ignition Cobalt X-3 Coupe Manual

4. Connections

4.1. Electrical connections

Electrical connections
If you wish to change the power supply settings, see the chapter Appendix. Connect the fixture to the If you wish to change the power supply
mains with the enclosed power cable and plug. The earth has to be connected. mains with the enclosed power cable and plug. The earth has to be connected.
Cable (EU)
Brown
Light blue
Yellow/Green

4.2. DMX connections

To make a DMX512 connection go ahead like it is described in the picture. Make s To make a DMX512 connection go ahead like it is described in the picture. Make s To make a DMX512 connection go ahead like it is described in the picture. Make sure that you use
shielded cable. 3pole or 5pole XLR cables are suitable. 3pole or 5pole XLR cables are suitable. If you use a controller with a 5 pin DMX output
connector, you will need to use a 5pin to 3 pin
4.3. DMX connection with terminator DMX connection with terminator
Where the DMX cable has to run cable has to run a long distance or the equipment is operated in an electrically
environment like a disco for installations
corruption of the digital control signal by electrical
connector with a 120 Ω resistor between pins 2
socket of the last device in the series.
settings, see the chapter Appendix. Connect the fixture to the
Cable (US) Cable (US)
Black
White
Green
use a 5pin to 3 pin adapter.
for installations, we recommend using a DMX terminator.
signal by electrical noise. The DMX terminator is simply an
between pins 2 and 3, which is then plugged into the
in the series. Please look to the bottom drawings.
Pin
Live
Neutral
Earth
If you use a controller with a 5 pin DMX output
terminator. This prevents
8 / 32
International International
L
N
in an electrically noisy
is simply an XLR
the XLR output