Adjusting The Interior Fittings; Adjusting The Door Shelf/Bottle Shelf; Moving The Shelf/Shelf With Lighting; Adjusting The Bottle Rack - Miele KFNS 37432 iD Operating And Installation Instructions

Adjusting the interior fittings

Adjusting the door shelf/bottle
shelf
Tip: Only move the door shelves/bottle
shelves in the door when they are
empty.
 Push the door shelf/bottle shelf up-
ward, then remove it by pulling it for-
ward.
 Replace the shelf at the required
height. Ensure that it is securely
pushed back into position.
Moving the shelf/shelf with
lighting
By adjusting the position of the shelf
with lighting in the refrigerator section,
you can change the illumination in this
section as required.
Stops prevent the shelves from being
dislodged by mistake.
 The shelves can be adjusted accord-
ing to the height of the food:
1. Lift the shelf up slightly at the front.
2. Pull it forward a little and lift it until
the notch at the side is in line with
the shelf support. It can then be
raised or lowered to the required
level.
 Push in the shelf until it clicks into po-
sition.
44
The raised edge on the protective strip
at the back must face upward to pre-
vent food from touching the back of
the appliance and freezing to it.

Adjusting the bottle rack

The bottle rack can be placed at differ-
ent positions in the machine.
 Lift the bottle rack slightly at the front,
pull it forward a little, lift the recess
over the shelf supports, and move the
shelf up or down.
The stop bar at the back must face up-
ward to prevent the bottles from touch-
ing the back wall.
Stops prevent the bottle rack from be-
ing dislodged by mistake.