Sip Config - ICP DAS USA SI-002 User Manual

3.2.7. SIP Config

Users can turn on the camera to take a photo or configure the dialing settings for SI-002, and click
the "Save" button to save the settings.. Remember to click the "Reboot" button to apply the new
settings.
Function Description
ON:
To enable the image shot function after dialing by SIP protocol. After the user
tap the call button on SI-002, the photo will be sent to HA-401.
Note: If the function is enabled, the user will receive the dial tone after
Camera Shots
calling for 3 seconds.
OFF:
Disable the image capture function
SI-002 will send the dial tone after the user tap the call button. If users do not
answer or hangs up the call after a timeout, the SIP will automatically end the
Ring Timeout call and stop ringing.
Note: If the input value is less than "2", the timeout value will be set to the
default value "180".
Save Click the "Save" button to save the settings
SI-002 User Manual, version 1.1
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Page: 28