Product CD Quick Start Technical Support SI-002 User Manual http://ftp.icpdas.com/pub/cd/ba-ha/si-002/user_manual SI-002 Website http://www.icpdas.com/root/product/solutions/ba_ha/si-002.html Overview Here is a brief overview of the components and its descriptions for module status. Front Panel SI-002 Quick Start (Version 1.00, Jun/2016) PAGE: 1...
LED Indicator is shown current status, as shown in the below. LED Action Current status High brightness On line Low brightness Off line Back Panel SI-002 Quick Start (Version 1.00, Jun/2016) PAGE: 2...
Page 3
FW Update Mode Recover system settings Other Ethernet Port An Ethernet port is an opening on SIP network equipment that Ethernet cables plug into. Ethernet ports accept cables with RJ- 45 connectors. SI-002 Quick Start (Version 1.00, Jun/2016) PAGE: 3...
Page 4
VoIP calls (person-to-person) via open SIP protocol. Connecting to Network, PC and Power The SI-002 is equipped with an RJ-45 Ethernet port for connection to an Ethernet hub/switch and PC. Please set RSW of SI-002 and PC Network as below.
Page 5
PJSIP stack for Windows OS. The user can use this Utility to connect with SI-002. Step 1: Get the MicroSIP Utility tool The MicroSIP Utility can be obtained from below link: http://www.microsip.org/downloads Step 2: Follow the prompts to complete the installation SI-002 Quick Start (Version 1.00, Jun/2016) PAGE: 5...
Page 6
Using SI-002 connect to MicroSIP Utility When RSW of SI-002 set to B, SI-002 will use a default IP settings to connect PC. The default IP settings are as follows: SI-002 192.168.72.30 IP Address 255.255.0.0 Subnet Mask PC side 192.168.255.1...
Page 7
Select audio codec (enable PCMU, PCMA, GSM) and video codec (enable H.263+) Step 3: Making a Phone call Press call button of SI-002 to call MicroSIP and then the MicroSIP will show Incoming call. Press "Answer with video" button of MicroSIP to answer call.
Page 8
Press "Answer with video" button of MicroSIP to answer call. At this time, the PC will show local video and remote video and hear voice from SI-002, it means the connection between PC and SI-002 module is established. SI-002 Quick Start (Version 1.00, Jun/2016)