Hardware Design - Ebyte E107-SC01 Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd
Data reception
Only E107-SC01-G support
Length
RSSI
MAC
Data

7. Hardware Design

It is recommended to use DC stabilized power supply to supply power to the module. The power supply ripple

coefficient is as small as possible, and the module needs to be reliably grounded.
Please pay attention to the correct connection of the positive and negative poles of the power supply. If the reverse

connection is connected, the module may be permanently damaged.
Please check the power supply to ensure that between the recommended supply voltage, if exceeding the maximum,

the module will be permanently damaged.
Please check the stability of the power supply, the voltage can not be significantly frequent.

When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the

margin, and the whole machine is beneficial for long-term stable operation.
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other

parts with large electromagnetic interference.
High-frequency digital traces, high-frequency analog traces, and power traces must be avoided under the module. If

it is necessary to pass through the module, assume that the module is soldered to the Top Layer, and the copper is
spread on the Top Layer of the module contact part(All copper-covered and well grounded), and must be close to
the digital part of the module and routed in the Bottom Layer.
Assuming the module is soldered or placed in the Top Layer, it is also wrong to randomly route the Bottom Layer or

other layers, which will affect the module's spurs and receiving sensitivity to varying degrees.
Assuming that there are devices with large electromagnetic interference around the module, the performance of the

Copyright ©2012–2019，成都亿佰特电子科技有限公司
E107-SC01-G C301071001（HEX）
Module restart
Command header 3 bytes
No reply
Data transmission
Only supported by E107-SC01-N
Command
<
header
Data 1～22 bytes
No reply
08H～1DH
00H～FFH
6 bytes（HEX）
1～22 bytes（HEX）
C4C4C4H
Fixed head
valid data
Length (including RSSI + MAC +
data)
RSSI strength
Sender MAC address
valid data
E107-SC01User manual
7-9