Concluding Treatment - Beurer FM 150 Pro Instructions For Use Manual

7. Press „timer" button to switch among three kinds of
timing time which are 10 minutes, 20 minutes and 30
minutes. When start up, the default is 20 minutes.
When the remaining time is 5 minutes, the current time
indicator slowly flashes; when the remaining time is
1 minute, the current time indicator quickly flashes.
8. In the process of using, if you feel the pressure is too
much or not comfortable, press the „stop" button to
stop the treatment.
Note
The device will now start to massage the legs alternately. The legs will never be massaged at the same
time. This is not an indication that the device is faulty.
The device features an automatic switch-off function, which is set to the maximum operating duration
of 30 minutes.
If the batteries are almost flat, the timer LEDs begin to flash from right to left. The device will switch off
after a few seconds and then be in a 30-second stand-by mode. During this time, all 3 timer LEDs light up.

9.2 Concluding treatment

To stop the treatment, you should first switch the device off and then let the air out of the cuffs.
Proceed as follows:
1. Switch the device off by pressing the
ON/OFF button on the hand switch. The
set timer LED goes out. The device is
now in standby mode for 30 seconds.
During this time, all 3 timer LEDs will be
activated.
2. Remove the air hose from the hand switch
within the 30 second standby mode and
insert the air hose into the air outlet
( ) on the side of the hand switch
and press the air outlet button [5].
All 3 timer LEDs flash at the same
time. They go out again when the
process has ended.
stop
23
stop
stop
stop stop