Advertisement
What is the vertical steam function used for? How do I use it?
This function allows you to iron fabrics in situ or on a hanger.
To do this, set the iron temperature button to the maximum position.
• Leave the item on a hanger and gently pull the fabric with one hand.
• Press the steam control button intermittently and move the iron from top to bottom.
As the steam produced is very hot, it softens the fibres and removes creases.
Note: Never use the vertical steam function on an item being worn by anyone.
Can I get steam on every setting?
Yes this is because the steam is generated in a separate area away from the soleplate of the iron.
This allows you to obtain steam on the lowest heat setting, e.g. silks. However, when the iron
temperature control is set to the lowest setting you must also set the steam output control dial
(depending on the model) to the low position, otherwise water droplets may appear in the steam.
How can I avoid scratching the soleplate of my iron?
To avoid damaging the soleplate, follow this advice:
• Always place your iron on its heel rest or its base (depending on model),
• Avoid ironing over abrasive items (buttons, zip fastenings, etc.),
• Never clean your iron's soleplate with abrasive or metallic pads.
How can I avoid shiny marks on fabric?
Shiny marks can appear on some fabrics, especially on dark coloured fabrics. We would advise
ironing dark clothes inside out and using the correct temperature.
If ironing mixed-fibre fabrics, set the temperature for the most fragile fibre.
Important: The iron takes longer to cool down than to heat up. We recommend that you start with
fabrics to be ironed at a low temperature.
Maintenance and cleaning
How do I maintain my steam generator?
Before any maintenance, make sure that the appliance is unplugged and that the soleplate, boiler
and iron rest have cooled down (at least 2 hours after ironing).
Do not use any maintenance or descaling product to clean the soleplate or the base unit. Never
hold the iron or its base unit under a running tap.
Cleaning the base unit:
• Wipe the plastic parts from time to time using a slightly damp soft cloth.
Maintaining the boiler (once a month):
• Please note: To prolong your boiler's efficiency and avoid scale deposits, you must rinse the
boiler every 10 uses (around once a month).
• Check that the generator is cool and has been unplugged for more than 2 hours.
• Slowly loosen the boiler cap. If your generator boiler has an anti-calc rod, take this out and
rinse it under the tap before placing it back in the boiler.
• Use a jug to fill the boiler with tap water until it is 3/4 full.
• Shake the base unit gently for a few seconds then empty it completely over the sink.
• For best results, we recommend that you perform this operation once again.
If you live in a hard water area, do this more often. Most of all, do not use any descaling
products to clean the boiler as they could damage it.
Advertisement
