Advertisement
10. Install the remaining panels/doors.
10.1 Align the pins with the holes in the bulkhead
connection panel and install the rear panel
(GM89752 or GM90714) on the alternator end of
the unit. See Figure 16 (item 1).
10.2 Align the pins with the holes in the base and install
the LH alternator panel (GM89751 or GM90713)
on the nonservice, alternator side of the unit. See
Figure 16 (item 2).
10.3 Align the pins with the holes in the base and install
the exhaust panel (GM89746 or GM90709) on the
nonservice side of the unit. See Figure 16 (item
3). Attach the top of the exhaust panel to the
mounting brackets in the top rail and secure using
two wing nuts (X-276-9). See Figure 13 for more
detail.
10.4 Align the pins with the holes in the base and install
the LH panel (GM89745 or GM90708) on the
nonservice side, engine end of the unit. See
Figure 16 (item 4).
10.5 Align the pins with the holes in the base and install
the front panel (GM89744 or GM90707) on the
engine end of the unit. See Figure 16 (item 5).
10
10.6 Align the pins with the holes in the base and install
the two RH panels (GM89743 or GM90706) to the
service side, engine end of the unit.
Figure 16 (item 6).
10.7 Align the pins with the holes in the base and install
the RH alternator panel (GM89748 or GM90711)
to the service side, alternator end of the unit. Place
decal (GM93648) on RH alternator panel. See
Figure 16 (item 7).
10.8 Position the controller panel (GM89749) as
shown in Figure 16 and attach to the mounting
brackets in the top rail and secure using two wing
nuts (X-276-9). See Figure 13 for more detail.
11. Restore the generator set to service.
11.1 Reconnect the leads that were disconnected in
step 1.6. Position the controller into the controller
panel and secure using the existing hardware and
gasket (removed in step 1.7).
11.2 Check that the generator set is OFF.
11.3 Reconnect the generator set engine starting
battery, the negative (--) lead last.
See
TT-1605 5/16
Advertisement
