Setting Water Hardness; Auto-Off; Energy Saving; Setting The Temperature - DeLonghi Magnifica S Smart ECAM 250.23.SB Manual

• if provided, the appliance performs a rinse cycle then goes
off (stand-by).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• first turn the appliance off by pressing the
• press the main switch (A6) to the "0" position.
Important!
Never press the main switch while the appliance is on.

6. SETTING WATER HARDNESS

For instructions on setting water hardness, see section "18. Set-
ting water hardness"

7. AUTO-OFF

The time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-off setting, proceed as follows:
1. With the appliance off (standby) and the main switch (A6)
in the I position (fig. 1), press and hold the
button (B9) until the lights (B1) on the control panel come
on;
2. Select the required time interval by pressing the
ton (B2):
3. Press the /
go off.
The auto-off time is now programmed.

8. ENERGY SAVING

Use this function to enable or disable energy saving. When ena-
bled, this mode reduces energy consumption in compliance with
current European regulations.
1. With the appliance off (standby) and the main switch (A6)
pressed (fig. 1), press and hold the
the light on the control panel comes on;
2. To disable the function, press the
light flashes;
3. To enable the function again, press the
again: the light comes on;
button;
/
15 min
30 min
1 hour
2 hours
3 hours
button (B9) to confirm. The lights
button (B4) until
button (B2). The
button (B2)
4. Press the
goes off.
The energy saving setting is now programmed.
Please note!
• When in energy saving mode, a few seconds may elapse before
the first coffee is delivered as the appliance must heat up
again.

9. SETTING THE TEMPERATURE

To change the temperature of the water used to make the cof-
fee, proceed as follows:
1. With the appliance off (standby) and the main switch (A6)
in the I position (fig. 1), press and hold the
(B2) until the lights on the control panel come on;
2. Press the
LOW
3. Press the
but-
tion. The lights go out.

10. WATER SOFTENER FILTER

Certain models are fitted with a water softener filter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services.
To use the filter correctly, follow the instructions below.

10.1 Installing the filter

1. Turn the appliance on and wait until it is ready for use.
2. Remove the filter (C4) from the packaging. The date indica-
tor disk varies according to the filter provided (fig. 8);
3. Turn the date disk to display the next 2 months of use.
Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last no longer than 3 weeks.
4. To activate the filter, run tap water through the hole in
the filter as shown in figure 9 until water comes out of the
openings at the side for more than a minute;
5. Extract the tank (A7) from the appliance and fill with
water;
6. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 10).
7. Insert the filter in the filter housing and press as far as it
will go (fig. 11);
9
/ button (B9) to confirm. The
button to select the required temperature:
/ button (B9) to confirm the selec-
light
button
HIGH