Zamel ledix ROP-04 Quick Start Manual

3-channel radio flush receiver
ROP-04
Mounting in a Ø60 Mounting
junction box indoor only
ROP-04 receiver is designed to carry out simple control functions in LED diode systems sup-
plied with 10 ÷ 14 V DC. In connection with EXTA FREE system transmitters, it enables the re-
alisation of the switch on/switch off function, the monostable mode, the bistable and time
modes. ROP-04 has 3 independently controlled outputs realised on MOSFET transistors. The
outputs are designed for a direct connection of LED diode products.
Characteristic features:
• cooperation with wireless EXTA FREE system transmitters,
• independent control of up to three receivers in the following modes: switch on/switch off,
monostable, bistable, time,
• 3 MOSFET type transistor outputs with a maximum capacity of 2,5 A / output,
• possibility of a direct connection of 10 ÷ 14 V DC power supply LED products to the re-
ceiver's outputs,
• wide operation range (up to 230 m outdoors),
• small dimensions - suitable for mounting in a typical Ø60 junction box,
• low power consumption in the standby mode (0,22 W) - the receiver is used to a continu-
ous operation.
PL 43-200 Pszczyna, ul. Zielona 27, Poland
tel: +48 32 449 15 00, fax: +48 32 449 15 02
10÷14 V DC / 0,22 W; IP20
weight: 25 g
CET Lighting Sp. z o.o. declares that
the equipment complies with the principal
requirements and other applicable rules
of the RTTE Directive.
The symbol means selective
collecting of electrical and electronic
equipment. It is forbidden to put
the used equipment together with
other waste.
Declaration of Conformity is on www.ledix.pl
SCAN
the technical
data
Co-operation
with EXTA FREE
transmitters
Cet Lighting Sp. z o.o.
e-mail: ledix@ledix.pl, www.ledix.pl
3-channel radio flush receiver
TYPE: ROP-04
ROP-04 ENG Ver. 01
3-channel
radio flush receiver
ROP-04
10 ÷ 14 V DC