Blood Glucose Testing - Abbott FreeStyle Libre 2 Manual

Blood Glucose Testing

You can use the built-in meter to check your blood glucose, whether you
are wearing a Sensor or not . You can perform a blood glucose test on
your fingertip or approved alternate site . Be sure to read the test strip
instructions for use prior to using the built-in meter .
Step
1
CAUTION: If you think you have low
glucose (hypoglycaemia) or you suffer
from hypoglycaemia unawareness,
test on your fingers .
Wash your hands and the test site with warm
soapy water for accurate results . Thoroughly dry
your hands and the test site . To warm the site,
apply a warm dry pad or rub vigorously for
a few seconds .
Note: Avoid areas near bones and areas
with lots of hair . If you get a bruise, consider
selecting another site .
55
ART41600-101_rev-A_manual.indd 55-56 ART41600-101_rev-A_manual.indd 55-56
Action
Step Action
2 Check the test strip expiry date .
D5
13758
2021/ 03
E .g . Expiry date:
March 31, 2021
3
Open the foil test strip packet at the notch and
tear down to remove the test strip . Use the test
strip immediately after removing from the
foil packet .
4
Insert the test strip with the three black lines at
the end facing up . Push the strip in until it stops .
5
Use your lancing device to obtain a blood drop
Apply Blood
and apply blood to the white area at the end of
the test strip .
If sounds are turned on, the Reader beeps once
to let you know you have applied enough blood .
Note: See test strip instructions for use for
re-application instructions .
56
10/7/20 2:55 PM 10/7/20 2:55 PM