Duramaxx 10028063 Manual page 12

Problem
The pump does not work
Pump is running but not pum-
ping water
Pump does not switch off .
The water volume pumped is
lower than expected
Pump switches off automati-
cally after a short while
According to the European waste regulation 2002/96/EG this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2011/65/EU (RoHS)
2014/30/EU (EMC)
Troubleshooting
Possible cause
No power supply?
Float switch does not work?
Water level too low?
Thermal protection was running.
Suction foot or fi lter blocked?
Dirt in the water?
Float switch cannot sink.
Suction foot or fi lter blocked?
Dirt in the water?
Motor protection (temperature
switch) stops the pump because
the water is too dirty (pump is
running hot) or too warm.
Environment Concerns
Declaration of Conformity
Possible solution
Check socket and plug.
Check the fl oat switch position.
Submerge the pump deeper in
the barrel.
Wait until the pump has cooled
down. Maybe you have to clean
the fi lter, suction foot or impeller
wheel.
Maybe you have to clean the
fi lter, suction foot or impeller
wheel.
Open and close the shut-off tap.
Check the fl oat switch position.
Maybe you have to clean the
fi lter, suction foot or impeller
wheel.
Pull the plug! Then clean the
pump and/or the water.
12