Installation and Operating Specification ETR
4 Mounting
4.1 General notes
Attention!
The following points must be complied with during the mechanical
installation to avoid causing a defect in the device due to assembly
errors or environmental influences:
Before installation remove the device from the packing and
•
check for any possible shipping damage!
Assemble the device on a clean and stable base. Do not
•
distort during assembly! Use the appropriate mounting devi-
ces for proper installation of the unit!
Do not mount equipment on vibrating base!
•
•
When mounted onto lightweight walls, there must be no im-
permissibly high vibrations or shock loads. Any banging shut
of doors that are integrated into these lightweight walls, can
result in extremely high shock loads. Therefore, we advise
you to decouple the devices from the wall.
Do not allow drilling chips, screws and other foreign bodies to
•
reach the device interior!
The device should be installed in a location where it will not
•
be disturbed, but at the same time can be easily accessed!
Any cable ducts openings not used must be sealed!
•
Care must be taken to avoid direct radiation from the sun!
•
The device is designed for vertical installation (cable inlet
•
down). A horizontal or reclined installation is only permissible
after technical release of the manufacturer!
4.2 Installation location for agriculture
In order to avoid damage caused by ammoniac vapours, the
controller shall not be installed in the stable, but rather in an
outhouse wherever possible.
L-BAL-E193-GB 1320
Part.-No.
7/20
Mounting