Preset Tuning - Yamaha TX-480 Owner's Manual

MANUAL PRESET TUNING
This unit can store station frequencies (selected by tuning operation) by using the preset station buttons. With this function, you can
select any desired station by only pressing the corresponding preset station button. Up to 40 stations (8 stations x 5 pages) can be
stored.
* Parts in shaded area are (
present on TX-580RDS only.
To store stations
1
Tune to a desired station.
(Refer to pages 7–8 for tuning procedure.)
2
Select a desired page (A – E) of preset station buttons
while watching the display.
A/B/C/D/E
3
MEMORY
MAN'L/AUTO FM
4
Press a preset station button before "MEMORY"
goes off from the display.
A/B/C/D/E 1 2 3
TX-480, TX-480L
PRESET
Shows the displayed station has been
programmed to A1.
TX-580RDS
PRESET
FM
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to the preset station
buttons on other pages in the same way by selecting
other pages in step 2.

PRESET TUNING

)
MEMORY
Flashes on and off
for about 5 seconds.
PRESET STATIONS
4 5 6 7 8
STEREO
MHz
0 20 40 60 l00
AUTO TUNING
STEREO
MHz
0 20 l00
AUTO TUNING
3 2,
1 1 4, 2 2
To recall a preset station
1 1
Select the page of preset station buttons.
A/B/C/D/E
2 2
A/B/C/D/E
Select the desired preset station button.
Notes
A new setting can be programmed in place of the former
one.
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is set off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the PRESET
TUNING steps.
(Preset station buttons)
PRESET STATIONS
1 2 3 4 5 6 7 8
9