Saving To Memory - Boss HYBRID DRIVE OD-200 Owner's Manual

Saving and Switching Memories

Saving to Memory

Here's how to save effect settings that you edited.
1.
Long-press the [MEMORY] button.
The display indicates "Wrt. "
2.
Press the [MEMORY] button to select the save-
destination (MAN, 1–4).
If you decide to cancel, press the [PARAM] button.
3.
Long-press the [MEMORY] button to confirm
the save-destination.
The memory is saved.
* If you save to MAN, the settings of the panel are applied as the
values for MODE, DRIVE, LEVEL, LOW, MIDDLE, and HIGH.
8
Switching Memories
Here's how to recall a saved memory.
1.
Press the [MEMORY] button to select a
memory.
Each time you press the button, you cycle through
the memories in the order of "MAN (manual) 0 1
0 2 0 3 0 4 0 MAN... "
What is "MAN" (manual)?
This unit normally applies the effect according to the
settings that are saved in memory, but if you select MAN
(manual) the effect is applied according to the positions
of the panel knobs. Even in this case, the booster and
gate settings recall the settings that are written to MAN
(this can be changed).