Viega MegaPress Z3 Actuator Instructions For Use Manual page 10

Viega MegaPress Z3 Actuator
10
NOTE! Before initiating a press make
sure the ball heads sit correctly in the
contact points of the press ring.
▶ Close the Z3 actuator.
▶ Hold the press tool and handle of the Z3
actuator securely.
▶ Start the pressing process by holding the
press tool trigger until the actuator has
engaged the press ring.
▷ When the press cycle is complete, the
actuator will stop and release. The
MegaPress press fitting will have been
pressed to the pipe.