TrekStor DataStation maxi Quick Manual page 6

EN
b) DataStation pocket (2.5 inch)
Use the provided USB Y-connection cable to connect the DataStation to your PC. Connect the mini-USB A-plug to
the DataStation pocket and both USB A-plugs to the USB port of your PCs. Your operating system will immediately
recognize the DataStation and will add the DataStation as a „Local Disk" (or „Local Drive") under "My Computer".
Note: TrekStor strongly recommends that its customers always insert both USB plugs. Insufficient power which may
occur when only one plug is inserted can cause data loss or even mechanical failure of the hard disk. TrekStor
assumes no liability or warranty for damage to the DataStation arising from insufficient power.
2) Exchanging data with the TrekStor DataStation
• Select the desired files or folders with your mouse. Copy these files by clicking them with your right mouse button
and then selecting „Copy".
• Under „My Computer", select the local disk „TrekStor".
• Click it with your right mouse button, and select „Paste" to start copying. After copying is over, the data will be
available on the DataStation.
3) Logging off and disconnecting the TrekStor DataStation from the PC
Windows 98 (SE) To log off the DataStation, click your right mouse button bar on the symbol
hardware" at the bottom right on the task bar. In the context menu that appears, click the left mouse button on
„Stop USB Mass Storage Device" to select it. You can now disconnect the DataStation from your PC.
– 6 –
„Safely remove