Connecting A Junos Space Appliance To A Management Console - Juniper Junos Space JA2500 Hardware Manual

Related
Documentation

Connecting a Junos Space Appliance to a Management Console

Copyright © 2014, Juniper Networks, Inc.
Figure 11: DC Power Supply Grounding
Connect the grounding lug to the earthing terminal using the screw, as shown in
9.
Figure 11 on page 41.
Attach the plastic safety cover.
10.
Close the input circuit breaker.
11.
The Junos Space Appliance starts powering on when you supply power to the power
supply module. If the power supply module is correctly installed and functioning normally,
the LED on the power supply module displays green when the power supply module is
powering the appliance, and amber when the power supply module is in standby mode
(not powering the appliance).
DC Power Grounding Requirements and Warning on page 147
DC Power Supply in Junos Space Appliances on page 15
General Electrical Safety Guidelines and Warnings on page 139
DC Power Disconnection Warning on page 145
DC Power Wiring Sequence Warning on page 148
DC Power Wiring Terminations Warning on page 149
Preventing Electrostatic Discharge Damage on page 140
This topic applies to the following Junos Space Appliances: JA1500 and JA2500.
You can configure and manage a Junos Space Appliance by using a dedicated console.
Every appliance has a console port with an RJ-45 connector. Use the console port to
connect the appliance to the management console or to a console server. Ensure that
you have an Ethernet cable with an RJ-45 connector available. An RJ-45 cable, as shown
in Figure 12 on page 42, and an RJ-45 to DB-9 serial port adapter are supplied with the
appliance.
Chapter 6: Connecting the Appliance
41