Table of Contents
Advertisement
Available languages
Available languages
General Information
About this Instruction Manual
Please read the safety instructions in this manual care-
fully. To avoid damage to the unit and the risk of injury,
only use this product as described in the manual.
Keep the instruction manual handy so that you can ea-
sily look up information on all the functions.
CAREFUL!
You will find this symbol before every
section of text that deals with the risk of
minor to severe injuries resulting from
improper
use.
NOTE!
You will find this symbol in front of every
section of text which deals with the risk
of damage to property or the environ-
ment.
Intended Use
This product is intended only for private use. It was
developed for experimentation with everyday natural
phenomena.
General Warning
RISK of bodily injury!
Never use this device to look directly at the sun or in the
direct proximity of
the sun. There is a RISK OF BLINDNESS!
Children should only use the device under adult super-
vision. Keep packaging material (plastic bags, rubber
bands, etc.) out of the reach of children! There is a
RISK OF CHOKING!
RISK of FIRE/EXPLOSION!
Do not place the device — in particular the lenses — in
direct sunlight. The concentration of light could cause
fire.
RISK of property damage!
Do not expose the device to temperatures above
60°C!
DE
GB
These are the parts of your experiment
box:
B
Blocks for mirrors (quadratic, type A) (6 pcs.)
C
Block for mirrors (rectangular, type B)
D
Block for mirrors (rectangular, type C)
E
Paper card with Junior Professor
F
Round stickers (32 pcs.)
G
Double-sided adhesive foam tape (10 pcs.)
H
Mirror plates (10 pcs.)
How to assemble the equipment
Step 1: Glueing foamed plastic adhesive tape
G
H
Figure 1
Double-sided adhesive foam tape (6)
Back of the mirror (7)
Figure 2
Backing paper from the double-sided adhesive foam
tape
Tear off a small piece of double-sided adhesive foam
tape (as shown in Figure 1) and stick it to the back
of the mirror (the green side). Then, take the backing
paper off the other side of the double-sided adhesive
foam tape (as shown in figure 2).
Advertisement
Table of Contents
