Advertisement
Fig. 5
Your hand-held vacuum comes with a rechargeable battery pack inside. The battery pack must
not be modified or changed. Any servicing required on the battery pack must only be undertaken
by an authorised Hoover Floorcare service agent. Please visit www.hooverfloorcare.com.au for
your closest agent.
At the end of life of this appliance, we suggest the battery pack is removed and disposed of in
accordance with your local municipal guidelines.
This product contains recyclable materials. Do not dispose of this product as
unsorted municipal waste. Please contact your local municipality for the nearest
collection point.
10
CARE AND CLEANING (cont)
BATTERY CARE AND DISPOSAL
OTHER
Wall Mounting
Your Hoover HandiVac comes with a specially designed bracket used to hold the recharging base
so that it may recharge while mounted on wall.
1. To mount the bracket, place it against the wall for the desired position, trace the mounting
holes of the bracket using a sharp pencil, onto the wall or mounting surface. Make sure the
wall bracket is vertically positioned.
2. Drill a diameter hole into each of the marked hole. Insert a plastic anchor into each hole.
3. Drive one screw into the upper anchor leaving the screw slightly exposed.
4. Place the bracket on the exposed portion of screw, slide the bracket downward to let the
screw go into the slot.
5. Insert the second screw through the bracket into the lower anchor, tighten it to secure the
bracket.
NOTE: Care must be taken when drilling into walls.
NOTE: There are two different wall mount charging bases depending on your model purchased.
FLOOR EXTENSION TOOL - 14.4V (HH5010WD) ONLY
The Hoover HandiVac 14.4 comes with a Floor extension tool.
This allows your hand-held vacuum to reach difficult spaces
such as down small spaces, ceiling cornices, along shelves
or simply down to the floor.
The four parts assemble easily. Insert the Inlet Fitting (part
iii) into the inlet of the hand-held vacuum. This will fit firmly
in place. Then take the two extension tubes (part ii) and join
together. Once together, one end will then fit into the Inlet
Fitting (part iii). Finally push the soft brush (part i) into the
open end of the extension Tube (part ii). You are now ready
to extend the use of your hand-held vacuum.
These extra parts are
able to conveniently
store on the special
Floor extension Tool
storage adaptor to
your Charging base –
as shown in Figure 2.
Figure 3 shows
extension Tool
assembly.
Fig. 2
(iii)
(i)
(ii)
Fig. 1
Fig. 3
11
Advertisement
