Exchanging Preset Stations - Yamaha RX-V595RDS Owner's Manual

Notes
• You can replace a preset station with another FM or AM station manually by simply following the procedures in the section "To
store stations" on page 30.
• The automatic preset tuning search will be performed through all RDS network frequencies until stations are stored up to E8.
Even if the number of received stations is not enough to be stored up to E8, the search is finished automatically after searching
all frequencies.
• With this function, only RDS stations with sufficient signal strength are stored automatically. If the station you want to store is
weak in signal strength, tune in to it in monaural manually and store it by following the procedures in the section "To store
stations" on page 30.
* There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This
is because this function receives a large volume of PI (Program Identification) data along with the station.

EXCHANGING PRESET STATIONS

You can exchange the places of two preset stations with each other as shown below.
Example
If you want to shift the preset station on E1 to A5, and vice versa.
1
Recall the preset station on E1 (by following the
procedures in the section "To recall a preset station" on
page 31).
2
Press EDIT.
Front Panel
2,4
3
4
Flashes.
Next, recall the preset station on A5 by following the
same procedures as in step 1.
Flashes.
Press EDIT once more.
Front Panel
Shows the exchange of
stations is completed.
33