VR's
LED, flashes 1x when it is detected, 3x when a command has been
received from the handheld transmitter.
Caution! The values can be set on the detector using a controller or
DALI handheld transmitter. If a detector has been set using a hand
transmitter, each controller can be activated individually by re-setting
the respective controller, or all controllers together using the reset
button on the hand transmitter (see instructions for use of the hand
transmitter).
SENS (sensitivity / range)
Range controller Max = approx.16m (30m RA) diameter
If the detector is too sensitive (occasional switch-on even though
"nobody" is in the detection area, e.g. in stairwells / chimney effect), the
sensitivity of the detector can be adjusted with this controller.
TIME
The timer can be used to determine how long the light stays on after
the last movement in the detection area. Min. Delay approx. 10
seconds to max. approx. 20 min.). Recommended setting: approx. 10
min in offices.
Test = Check the detection area with a short
Follow-up time (3s on, 6s off)
4
Zubehör: DALI Handsender.