TP-Link M7000 Quick Installation Manual

Quick Installation Guide
Mobile Wi-Fi
* Images are for demonstration only.
LED Indicators
LED Status Explanation
On/Off Wi-Fi is enabled or disabled.
(Wi-Fi)
On/Off Internet service is available or unavailable.
(Internet)
Solid Green Mobile Wi-Fi has enough power or is fully charged.
Blinking Red The battery level is lower than 10%.
(Battery)
Blinking Green Mobile Wi-Fi is charging.
Off Power is off.
The LEDs will turn off automatically after idling for 30 seconds. To check the LED
!
status, press the Power button to turn them on again.
1. Install the SIM Card and Battery
a. Remove the back cover. b. Install your SIM card.
SIM card requirement:
!
Standard
SIM card Provided Micro SIM card adapter + Provided sticker
2. Connect to the Internet
a. Press and hold the Power button b. Connect your wireless device to the Mobile Wi-Fi using the
to power on the Mobile Wi-Fi. SSID and the Wireless Password you have noted down.
· If you cannot access the internet, refer to FAQ > Q1.
!
· By default, Power Saving is enabled and the Mobile Wi-Fi will turn off Wi-Fi when no wireless devices are connected to it for 10 minutes.
To resume the Wi-Fi connection, press the Power button.
c. Install the provided battery.
1
2
+ +
+ +
Micro SIM card + Nano SIM card +
Provided Nano SIM card adapter + Provided sticker
SSID:
< Settings Wi-Fi
TP-Link_XXXX
Wi-Fi Wireless Password:
CHOOSE A NETWORK...
XXXXXXXX
TP-Link_XXXX
Other...
d. Note down the default SSID and Wireless
Password. Then replace the cover.
SSID:
TP-Link_XXXX
Wireless Password:
XXXXXXXX
Enjoy the internet!