Operations - Yamaha RX-460 Owner's Manual

TO PLAY A SOURCE
1
Set to the "
2
3
Select a desired input source.
MONITOR
AUX
TAPE 2 TAPE 1
COPY
* The name of the selected input source will appear in the
display.
* Note that pressing on each input selector selects the
source which is connected to the corresponding input
terminals on the rear panel.
4
Select the speakers to be used.
SPEAKERS
A
ON
OFF
* If you use two speaker systems, press both the A and B
switches.

OPERATIONS

2
4
VOLUME
0
— dB
∞
" position.
POWER
INPUT
TUNER CD PHONO
B
ON
OFF
3
7
5
Play the source. (For detailed information on the tuning
operations, refer to the page 10.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (Refer to page 9.)
Note
In the step 3, if two or more program sources are selected at
the same time (by using input selectors), be sure to remember
the priority order of the input sources.
Priority order of sources: 1) TAPE 1, 2) TAPE 2, 3) AUX,
TUNER, CD or PHONO.
If you select AUX, TUNER, CD or PHONO, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
If you select both AUX and TAPE 1 at the same time, the
result will be the sound from the tape deck 1.
1,6
VOLUME
0
— dB
7