Yamaha HTR-6180 Owner's Manual page 105

■ HDMI set
E)HDMI SET
Use this feature to select the component to play back
HDMI audio signals.
E)HDMI SET
S. AUDIO;;;;HTR-6180
[p]/[[]:
[ENTER]:
Support audio S.AUDIO
Use this feature to select whether to play back HDMI
audio signals on this unit or on another HDMI component
connected to the HDMI OUT jack on the rear panel of this
unit.
Choice
HTR-6180
Plays back HDMI audio signals on this unit. The
HDMI audio signals input at the HDMI input
jacks of this unit are not output to the HDMI
component connected to the HDMI OUT jack on
the rear panel of this unit.
OTHER Plays back HDMI audio signals on another
HDMI component connected to the HDMI OUT
jack.
Notes
• This unit transmits audio and video signals input at the HDMI
input jacks to the HDMI out jack only when this unit is turned
on even if "S.AUDIO" is set to "OTHER".
• Available audio/video signals depend on the specification of the
connected video monitor. Refer to the instruction manual of
each connected component.
Select
Return
Functions
Customizing this unit (MANUAL SETUP)
■ Zone 2 settings
F)ZONE2 SET
. MAX VOL.;;;+16.5dB
INIT. VOL.;;;;;OFF
[ ]/[ ]:
[p]/[[]:
Zone 2 Maximum volume MAX VOL.
Use this feature to set the maximum volume level in the
Zone 2.
Control range: – 30.0 dB to +15.0 dB, +16.5 dB
Control step: 5.0 dB
Notes
• The "MAX VOL." setting takes priority over the "INI.VOL."
setting. For example, when "INI.VOL." is set to –20.0 dB and
then "MAX VOL." is set to –30.0 dB, the volume level is
automatically set to –30.0 dB when you turn on the power of
this unit next time.
• The "MAX VOL." setting does not affect the output level at the
"ZONE 2 OUT" jacks.
Zone 2 Initial volume INI.VOL.
Use this feature to set the volume level of Zone 2 when the
power of this unit is turned on.
Choices: OFF, MUTE, –80.0 dB to +16.5 dB
Control step: 0.5 dB
Notes
• The "MAX VOL." setting takes priority over the "INI.VOL."
setting.
• When you select "FRONT B", "PRNS", "Zone B", or "NONE"
in "EXTRA SP ASSIGN" (see page 87), "Zone 2 SP Not
Assigned" appears in the OSD and the "ZONE2 SET"
parameter is not available.
• The "INI.VOL." setting does not affect the output level at the
"ZONE 2 OUT" jacks.
F)ZONE2 SET
Up/Down
Adjust
101
En