Denon HEOS Super Link Owner's Manual page 41

Contents
Adjusting the equalizer
1
Select "EQ".
2
Adjust the "Treble" or "Bass" up or down.
0 Select the Reset button to restore the default settings.
0 You can also configure settings by tapping S in the Now Playing screen.
Adjusting the balance
1
Select "Balance".
2
Adjust the Balance to the left or right.
Adjusting the output mode
1
Select "Output Mode".
2
Select Stereo or Dual Mono.
Setup Use Troubleshooting
Adjusting the audio quality
Selects the transcoding option for rebroadcasting audio from one HEOS
device to another HEOS device (or group of devices) across the network.
When set to "Normal", high bit rate audio sources originating from the first
device (such as AUX input, WAV, FLAC and PCM) will be transcoded to
ensure the highest level of reliability for the audio stream.
1
Select "Quality".
2
Select "Normal" (default) or "High".
0 If you have selected High and you experience audio dropouts when streaming
sources from one device to other devices, please select Normal (default).
Adjusting the volume limit
You can set the maximum volume of the HEOS Super Link amplifiers to
prevent sudden loud volume.
1
Select "Volume Limit".
2
Select the maximum volume percentage (95, 90, 85,
80).
NOTE
0 Depending on the speakers that are connected, the protection circuit may activate
and the power may be turned off when music is played at a high volume. (The
Power indicator flashes in red.) If this happens, configure the "Volume Limit"
setting.
41
Status LED Appendix