Connecting The Antennas - Yamaha HTR-5790 Owner's Manual

Yamaha av receiver owner's manual
Table of Contents

Advertisement

Connecting the antennas

Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
AM loop antenna
(included)
COMPONENT VIDEO
P
P
Y
R
B
VD
TV
ONITOR OUT
TUNER
AM
ANT
MAIN
GND
FM ANT
75Ω
UNBAL.
SURRO
SUB
WOOFE
Ground (GND terminal)
For maximum safety and minimum interference,
connect the antenna
ground. A good earth ground is a metal stake driven
into moist earth.
Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it
to the terminals on this unit.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND
terminals.
3
Orient the AM loop antenna for the best
reception.
Indoor FM antenna
(included)
GND
terminal to a good earth
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A property installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
75-ohm/300-ohm antenna adapter
(U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
3
Cut the lead wire and
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
Insert the wire
into slot.
5
Snap the cover
into place.
FREQUENCY STEP switch
(Asia and General models only)
Because the interstation frequency
spacing differs in different areas, set
the FREQUENCY STEP switch
(locating on the rear panel) according
to the frequency spacing in your area.
• North, Central and South America: 100 kHz/10 kHz
• Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit's AC
power cord from the wall outlet.
CONNECTIONS
11 (7/16)
Unit:
8 (5/16)
mm (inch)
6 (1/14)
Lead wire
Clamp
Clamp
100kHz/10kHz
50kHz/9kHz
FM
AM
FREQUENCY
STEP
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-v1400Rx-v1400rds

Table of Contents