Zone 2/Zone 3; (U.s.a., Canada And Australia Models Only); Zone 2/Zone 3 Connections - Yamaha HTR-5790 Owner's Manual

ZONE 2/ZONE 3 (U.S.A., CANADA AND AUSTRALIA MODELS ONLY)

(U.S.A., CANADA AND AUSTRALIA MODELS ONLY)

This unit allows you to configure a multi-room audio system. The Zone 2 and Zone 3 features enable you to set this unit
to reproduce separate input sources in the main room, second room (Zone 2) and third room (Zone 3). You can control
this unit from the second room using the supplied remote control.
Only analog signals are sent to the second and third rooms. Any source you want to listen to in the second or third
room must be connected using the analog (AUDIO L/R) input jacks on this unit.

Zone 2/Zone 3 connections

You need the following additional equipment to use the multi-room functions of this unit:
• An infrared signal receiver in the second and/or third room.
• An infrared emitter in the main room. This emitter transmits the infrared signals from the remote control in the second
and/or third room to the main room (to a CD player or LD player, for example).
• An amplifier and speakers for the second and/or third room.
OUT IN OUT
System configuration and connections example
Using external amplifiers
To use an external amplifier in Zone 2, select OFF in ZONE2 AMP.
DVD player
(or other component)
Main room
Notes
• When not using the main room, turn down the volume of this unit in the main room. Adjust the ZONE 2/ZONE 3 volume by using the
amplifier in the second/third room. When using the remote control to adjust the ZONE 2 volume, set the volume of the amplifier in the
second room to the maximum level you will use, and select VAR. in ZONE 2 SET OUTPUT VOL (page 58).
• To avoid unexpected noise, DO NOT USE the Zone 2/Zone 3 feature with CDs encoded in DTS.
68

ZONE 2/ZONE 3

REMOTE
IN CONTROL OUT
This unit
This unit
DVD INPUT
Infrared emitter
REMOTE CONTROL OUT
y
• Since there are many possible ways to connect and use this unit
in a multi-room installation, we recommend that you consult
with the nearest authorized YAMAHA dealer or service center
for the Zone 2/Zone 3 connections which will best meet your
requirements.
• Some YAMAHA models are able to connect directly to the
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter. Up to 6
YAMAHA components can be connected as shown.
ZONE 2 AUDIO OUT
Amplifier
Remote control
Infrared signal
receiver
Second room
ZONE 2 REMOTE IN
ZONE 3 AUDIO OUT
Amplifier
Third room