WMF Lono 230775 Instruction Manual page 7

Glass toaster
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 6
▪ When cleaning, do not insert your fingers or any objects (e.g. fork, knife, or similar) into the bread
slot.
▪ Caution, glass breakage: remove and insert the glass plates carefully and only for cleaning.
▪ Do not use any sharp or sharp-edged objects on the glass plates as they could otherwise damage
the glass plates.
▪ Warning: risk of burns: never use the toaster without the glass plates inserted.
▪ Only operate the toaster when upright and away from other objects.
▪ Do not cover the bread slots during toasting. Do not lay any bread slices or rolls on the casing, as
this causes the device to overheat.
▪ No liability shall be accepted for any damage resulting from misuse, incorrect operation or
improper repairs. Warranty claims will be deemed invalid in such cases.
▪ Grip of roll attachment is not a handle. Only touch the roll attachment when it is cooled down.
▪ If toast of small bread slices is less than 85mm length, the user must pay attention to the potential
risk of burning when taking out the slices.
Danger of suffocation!
Do not allow children to play with packaging materials.
Using the appliance
This toaster is suitable for slices of bread (up to a size of 13 x 13 cm), braided rolls and similar baked
goods with a maximum thickness of 2.6 cm. Do not use it for baked goods with fillings or spreads, e.g.
butter or jam.
Using the appliance for the first time
Any unnecessary length of the power cable can be wound in at the base of the device. Plug in the
power cable and press the On/Off button to switch on the device.
Prior to the first use, run the toaster through at least one toasting cycle without bread at the
maximum browning setting in order to remove the surface protection from the heating elements. The
resulting odour is harmless, but this should nevertheless be performed in a well-ventilated area. Allow
the device to cool off somewhat before each toasting process.
Insert the bread slices into the bread slot. To make sure that they do not jam, they should be no
thicker than 2.6 cm. Place small slices next to one another in an upright position in the bread slot so
that it is easier to take them out after toasting.
Use the "+"/"-" buttons initially to set the medium browning level and then press the Start/Stop
button
. The motor switches on and moves the toast downwards until the toasting time expires. The
device then switches off automatically and the finished toast is raised from the bread slot for removal.
Caution: The device is still ready to use (LED display illuminated) until the On/Off button is pressed to
switch off the toaster (LED display disappears).
Information about the degree of browning
If the toast is too light, select a higher browning level. If the toast is too dark, move the browning
level to a lower setting. The LED display is only useful as a guide. The greater the number of illumi-
nated LEDs, the darker the browning. The toasting result can vary for the same setting depending on
the bread type, size, moisture content and thickness of the slices. Therefore, choose a lower setting for
less moist bread, smaller slices and also when toasting just one slice of bread. When toasted too darkly,
concentrated acrylamide forms. You should therefore avoid toasting too darkly.
12
Single-sided toasting
Ideal for baguettes, rolls and bagels. For single-sided toasting of a baguette, for example, cut the
baguette lengthwise. Place it in the bread slot so that the cut side is facing the front. If the bagel but-
ton is pressed immediately after starting, the slice of bread will only be toasted on its front side.
Warming up / secondary toasting
If the warm-up button is pressed immediately after starting the device, already cooled off toast
is warmed up again to become crispy (regardless of the set degree of browning) and light bread is
somewhat toasted.
Thawing
If the button is pressed immediately after starting, the toasting cycle is automatically extended to
toast frozen bread.
Stopping the toasting cycle
To stop the cycle early, press the illuminated Start/Stop button.
Roll attachment
The toaster has a roll attachment that can be fitted if needed. Two rolls can be baked from both sides,
each with the lowest setting. Slightly wet bread that is too dry beforehand so that it toasts better.
Note: only use the roll attachment on the lowest setting, otherwise there is a risk of the device
overheating.
Crumb tray
Falling crumbs are collected in the crumb tray during toasting. To empty, briefly press against the
crumb tray. You will then be able to pull it out of the device.
13

Advertisement

Table of Contents
loading

Table of Contents