Honeywell F116 Series Product Data page 10

F116 SERIES 2 SELF-CONTAINED DUCTABLE COMMERCIAL AIR CLEANER
WARNING
Remove packing materials / Parts from inside
the Motor / Blower compartment prior to
installation or initial power on.
Mount Air Cleaner Cabinet
The F116 Series 2 air cleaner must be attached to a
structure capable of supporting the weight of the unit with
filters, ducting and plenums when used. Roof trusses, bar
joists and floor joists are examples of suitable structures.
IMPORTANT
All suspension points (either six or eight depend-
ing on the model) must be used for proper and
safe installation. See Fig. 1 and 2 for dimensions
between the suspension points.
Threaded rod, eyebolts with chains, or any standard
practice and hardware for hanging method can be used in
the suspension of the air cleaner. See Fig. 12.
NOTE: State and local codes and accepted installation
practices must be followed.
FASTEN SECURELY TO STRUCTURAL SUPPORT SYSTEM
I.E. BAR JOIST, CONCRETE SLAB, TIMBER FRAMING, ETC.
ALL EXTERNAL HARDWARE
FURNISHED BY OWNER.
THREADED
ROD
JAM
NUT
TOP OF
AIR CLEANER
CABINET
3/8 x 16T NUTS INSTALLED
IN CABINET CORNERS
Fig. 12. Fastening air cleaner to a structural support
system (bar joist, concrete slab, or timber framing).
Installation with Ducting
Use a transition or box plenum to attach the ducting to the
air cleaner inlet and outlet. On the inlet, a transition
plenum is preferred, see Fig. 13.
68-0200—07
CHAIN
HEX BOLT
LOCK
WASHER
EYEBOLT
JAM NUT
3/8 x 16T
M10802
10
Fig. 13. Transition plenum connected to the air cleaner
If a box plenum is used on the inlet, a diffusion screen
must be installed in the box, see Fig. 14. A box plenum can
accommodate more than one inlet
DIFFUSION
SCREEN
Fig. 14. Box plenum with diffusion screen and three
inlets connected to the air cleaner inlet.
On the outlet, use a square-to-round or square-to-square
connection when attaching the air cleaner outlet to the
blower discharge flange, see Fig. 15. The outlet
connection can be used with a Y-branch, distribution box
or manifold as required.
Y-BRANCH
Fig. 15. Square-to-round connection attached to the air
cleaner outlet.
AIR CLEANER
M7793A
inlet.
AIR
CLEANER
M10803
AIR CLEANER
SQUARE-TO-ROUND
M7792A
CONNECTION