ECOVACS ROBOTICS DEEBOT OZMO 960 Instruction Manual page 5

Appliance over the power cord. Keep power cord away from hot
surfaces.
20. If the power cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
21. Do not use the Docking Station if it is damaged. The power
supply is not to be repaired and not to be used any longer if
it is damaged or defective.
22. Do not use with a damaged power cord or receptacle. Do
not use the Appliance or Docking Station if it is not working
properly, has been dropped, damaged, left outdoors, or
come in contact with water. It must be repaired by the
manufacturer or its service agent in order to avoid a hazard.
23. Turn OFF the power switch before cleaning or maintaining
the Appliance.
24. The plug must be removed from the receptacle before
cleaning or maintaining the Docking Station.
25. Remove the Appliance from the Docking Station, and turn
OFF the power switch to the Appliance before removing the
battery for disposal of the Appliance.
26. The battery must be removed and discarded according to
local laws and regulations before disposal of the Appliance.
27. Please dispose of used batteries according to local laws and
regulations.
28. Do not incinerate the Appliance even if it is severely
damaged. The batteries can explode in a fire.
29. When not using the Docking Station for a long period of
time, please unplug it.
30. The Appliance must be used in accordance with the directions
in this Instruction Manual. ECOVACS ROBOTICS cannot be
held liable or responsible for any damages or injuries caused
by improper use.
1. Important Safety Instructions
31. The robot contains batteries that are only replaceable by
skilled persons. To replace the robot's battery, please contact
Customer Service.
32. If the robot will not be used for a long time, power OFF the
robot for storage and unplug the Docking Station.
33. WARNING: For the purposes of recharging the battery, only
use the detachable supply unit CH1822 provided with the
Appliance.
To satisfy RF exposure requirements, a separation distance of 20 cm or
more should be maintained between this device and persons during
device operation.
To ensure compliance, operations at closer than this distance is not
recommended. The antenna used for this transmitter must not be co-
located in conjunction with any other antenna or transmitter.
Class II
Short-circuit-proof safety isolating
transformer
Switch mode power supply
For indoor use only
5
EN